Physical, Thermal and Microstructural Effect of CO2 in Carbonic Acid on Mortar
DOI:
https://doi.org/10.24191/mjcet.v8i2.5012Keywords:
Carbon dioxide, Calcium carbonate, CarbonationAbstract
Existing studies have shown current methods of carbon dioxide infusion are limited to slow carbonation rates and lack of carbon dioxide penetration. This study aims to tackle these problems by proposing a new method of infusion by adding carbon dioxide via liquid directly during mixing process. This study also investigates the thermophysical behaviour of mortar subjected to liquid-phase CO₂ infusion, focusing on its effects on mechanical strength, hydration, and carbonation processes. Mortar specimens were prepared and infused with carbonic acid during mixing, followed by compressive strength testing, thermogravimetric analysis (TGA), and scanning electron microscopy (SEM). The results indicate that liquid-phase CO₂ infusion increases calcium carbonate (CaCO₃) formation, as confirmed by SEM observations of calcite crystallisation. Compressive strength measurements showed that 100% infusion CO₂ mortar does surpass normal mortar mixture showing potential in this method. TGA revealed that the amount of CO₂ retained or released is highly dependent on the mixing and curing conditions, but higher infusion does results in high amount of calcite form, with hydration dynamics significantly influencing the final strength. This is supported by SEM results showing more calcium carbonate formed for all samples but also the formation of pores due to high water content inside mortar.
References
Akhila, J., & Rao, N. V. (2023). Experimental investigation on carbonation of concrete using SEM –EDX(scanning electron microscopy (SEM) with energy dispersive x-ray analysis (EDX) & environmental scanning electron microscope(ESEM) analysis. IOP Conference Series: Earth and Environmental Science, 1130(1). https://doi.org/10.1088/1755-1315/1130/1/012022
Alimi, W. O., Adekunle, S. K., Ahmad, S., & Amao, A. O. (2022). Carbon dioxide sequestration characteristics of concrete mixtures incorporating high-volume cement kiln dust. Case Studies in Construction Materials, 17, e01414. https://doi.org/10.1016/j.cscm.2022.e01414
Ashraf, W. (2016). Carbonation of cement-based materials: Challenges and opportunities. Construction and Building Materials, 120, 558–570. https://doi.org/10.1016/j.conbuildmat.2016.05.080
Choi, H., Choi, H., Inoue, M., & Sengoku, R. (2017). Control of the polymorphism of calcium carbonate produced by self-healing in the cracked part of cementitious materials. Applied Sciences, 7(6), 546. https://doi.org/10.3390/app7060546
Joel André. (2017). Mixing cement with carbon dioxide – Effect on early hydration. [Bachelor’s Degree Thesis, Chalmers University of Technology] Chalmers Publication Library. https://publications.lib.chalmers.se/records/fulltext/250462/250462.pdf
John Adabara, R. L., Joseph, I. O., Olaonipekun, O.A., Sina-olulana, O.O., Dotun, O., Adekunle, S.S., Abayomi, E.M, Olumoyewa, D.A., & Oyebisi, S. O. (2019). Compressive strength analysis of conventional design concrete mix ratio; 1:2:4 and non-conventional concrete mix ratio; 1:3:3 for the construction industry in Nigeria. International Journal of Civil Engineering and Technology, 10(1), 1133–1141. https://www.researchgate.net/publication/331043840
Kamal, N. L. M., Itam, Z., Sivaganese, Y., & Beddu, S. (2020). Carbon dioxide sequestration in concrete and its effects on concrete compressive strength. Materials Today: Proceedings, 31(1), A18–A21. https://doi.org/10.1016/j.matpr.2020.11.185
Karunadasa, K. S. P., Manoratne, C. H., Pitawala, H. M. T. G. A., & Rajapakse, R. M. G. (2019). Thermal decomposition of calcium carbonate (calcite polymorph) as examined by in-situ high-temperature X-ray powder diffraction. Journal of Physics and Chemistry of Solids, 134, 21–28. https://doi.org/10.1016/j.jpcs.2019.05.023
Khalid, F. S., Aminuddin, M. Y. A., Al-Jaberi, A. N. A., Zaki, Z., Irwan, J. M., Ayob, S., & Tayeh, B. A. (2021). The determination of optimum ratio by using recycled concrete aggregate and crumb rubber as partial sand replacement material in sand cement brick production. International Journal of Nanoelectronics and Materials, 14(Special Issue), 29–42.
Lee, M. G., Wang, W. C., Huang, Y., Su, Y. M., & Quanzhou, J. (2017). Effect of carbon dioxide curing on strength development of cement mortar. Key Engineering Materials, 748, 323–327. https://doi.org/10.4028/www.scientific.net/KEM.748.323
Lippiatt, N., & Ling, T. C. (2020). Rapid hydration mechanism of carbonic acid and cement. Journal of Building Engineering, 31, 101357. https://doi.org/10.1016/j.jobe.2020.101357
Liu, Z., & Meng, W. (2021). Fundamental understanding of carbonation curing and durability of carbonation-cured cement-based composites: A review. Journal of CO2 Utilization, 44, 1012428. https://doi.org/10.1016/j.jcou.2020.101428
Lu, B., Shi, C., Cao, Z., Guo, M., & Zheng, J. (2019). Effect of carbonated coarse recycled concrete aggregate on the properties and microstructure of recycled concrete. Journal of Cleaner Production, 233, 421–428. https://doi.org/10.1016/j.jclepro.2019.05.350
Monkman, S., & MacDonald, M. (2017). On carbon dioxide utilization as a means to improve the sustainability of ready-mixed concrete. Journal of Cleaner Production, 167, 365–375. https://doi.org/10.1016/j.jclepro.2017.08.194
Park, S. H., Ryu, H. S., & Park, W. J. (2024). Influence of unit water content control on concrete performance in the ready-mixed concrete production process. Materials, 17(4), 834. https://doi.org/10.3390/ma17040834
Patil, P. (2021). Experimental study of fresh and harden properties of concrete infused with carbon dioxide. In L.M., Gupta, M.R. Ray, P.K. Labhasetwar (Eds.), Advances in civil engineering and infrastructural development. Lecture notes in civil engineering (Vol. 87, pp. 645–653). Springer, Singapore. https://doi.org/10.1007/978-981-15-6463-5_63
Qian, X., Wang, J., Fang, Y., & Wang, L. (2018). Carbon dioxide as an admixture for better performance of OPC-based concrete. Journal of CO2 Utilization, 25, 31–38. https://doi.org/10.1016/J.JCOU.2018.03.007
Qureshi, A. U. (2020). Experimental studies of different RCC structural. Concepts Book Publication India Pvt. Ltd.
Šavija, B., & Luković, M. (2016). Carbonation of cement paste: Understanding, challenges, and opportunities. In Construction and Building Materials, 117, 285–301. https://doi.org/10.1016/j.conbuildmat.2016.04.138
Scrivener, K. L., Snellings, R., & Lothenbach, B. (2016). A practical guide to microstructural analysis of cementitious materials. CRC Press, Taylor & Francis Group.
Tam, V. W., Butera, A., Le, K. N., & Li, W. (2021). CO2 concrete and its practical value utilising living lab methodologies. Cleaner Engineering and Technology, 3, 100131. https://doi.org/10.1016/j.clet.2021.100131
Villain, G., Thiery, M., & Platret, G. (2007). Measurement methods of carbonation profiles in concrete: Thermogravimetry, chemical analysis and gammadensimetry. Cement and Concrete Research, 37(8). https://doi.org/10.1016/j.cemconres.2007.04.015
Vogler, N., Drabetzki, P., Lindemann, M., & Kühne, H. C. (2022). Description of the concrete carbonation process with adjusted depth-resolved thermogravimetric analysis. Journal of Thermal Analysis and Calorimetry, 147(11), 6167–6180. https://doi.org/10.1007/s10973-021-10966-1
Winnefeld, F., Leemann, A., German, A., & Lothenbach, B. (2022). CO2 storage in cement and concrete by mineral carbonation. Current Opinion in Green and Sustainable Chemistry, 38, 100672. https://doi.org/10.1016/J.COGSC.2022.100672
Zhang, D., Ghouleh, Z., & Shao, Y. (2017). Review on carbonation curing of cement-based materials. Journal of CO2 Utilization, 21, 119–131. https://doi.org/10.1016/j.jcou.2017.07.003
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2025 Muhammad Irfan Khumaini Kamaruhisam, Miradatul Najwa Muhd Rodhi, Mohd Fadzil Arshad, Mohd Syazwan Mohd Syukor, M Ghaddaffi M Noh
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
